Jeremy's Money Shot
Modifications
Jeremy Bell's "Money Shot" is destroying pavement left and right up North with its super low stance courtesy of a full 1/2-inch air ride system and 3.5-inch traditional bodydrop set over a set of 17-inch Eagle Alloy rims. Not satisfied with the stock appearance the Bow Tie factory presented, Jeremy proceeded to give the truck a full shave job with the Chevrolet lettering run across the roll pan. He also added a 2.5-inch cowl-induction hood, billet grille, chrome bumper, crystal marker lights, and clear taillights to round out the mods.
Owner: Jeremy Bell
Ontario, Canada
1989 Chevy S-10
Resurrected Hardbody
Modifications
The resurrection of Paul Devine's Nissan has not been an easy one. After replacing every body panel, installing a new brake system all the way around, along with other life-saving mods, Paul's mini was ready to hit the streets. With full air ride utilizing a reverse four-link, raised gas tank, Firestone 'bags and 1/2-inch SMC valves, Project Resurrected was ready to cruise! The cabin is comforting with a 1997 Hardbody dash swap, recovered Subaru seats, tweed door panels and center console, and a bumpin' JL Audio system. Paul definitely helped this Nissan pull its foot out of the grave.
Owner: Paul Devine
Philadelphia, PA
1992 Nissan Kingcab
Ol' Skool Kool
Modifications
Andrew Folta has a thing for things that are kool-especially old-skool kool! As you can see from his slammed S-10, he definitely has things headed in the right direction-down to the ground. Andrew's mini is brought to the pavement with 'bags all the way around and SD cups up front with Slam Specialties RE-7s. The rear comes down with an FBI bolt-on four-link. The air system helps the Dime sit low over a set of 15x8 Cragar Smoothies wrapped in NOS Gateway whitewalls from the early 1980s. As you can see, Andrew is definitely keepin' it old-skool kool.
Owner: Andrew Flota
Springfield, Mo
2002 Chevy S-10